|
 |
Question:
Hello,
We are looking to get an idea about likely costs to lift 3 - 20x20 wood frame/siding cottages that are currently sitting on blocks. We have been told by our building inspector that these cottages need to be raised as the wooden support beams are resting too low to the ground and current height does not allow enough air flow to ensure the structure won't deteriorate.
Are you able to give us a ballpark figure of how much this endeavor is likely to cost us?
Thank you!
Ralph & Linda Bramer
Answer:
Hi there Mr. & Mrs. Bramer
To raise and lower the two cottages will be approximatly $ 4,000.00 each.
Thanks
Tony
Answered By: Tony D'Angelo
More Questions & Answers ...
| 1. |
I'm looking for some independent information suporting the benefits of pressure treated wood foundations.
I h ... |
| 2. |
Mr. D'Angelo, I want to finish the basement for a family romm.The basement floor is dry and in good condition. ... |
| 3. |
I have lived in my house for over 25 years (house was built 1825), and I am renovator a room, and will add ano ... |
| 4. |
Hi Tony,
I put in a rock pool, waterfall, fire place and bar-b-que only to come up short financially to co ... |
| 5. |
Hello,
We are looking to get an idea about likely costs to lift 3 - 20x20 wood frame/siding cottages that ... |
| 6. |
Hi,
I have some cracking and chipping damage on my front concrete steps probably due to wear & tear and rock ... |
| 7. |
Hi Tony,
My new house due Nov 15 has the wrong colour shingles installed (builder error). Should I have the n ... |
| 8. |
Hi:
I am renting a house with apartments in the basement. One of those tenants is a smoker and her cigaret ... |
| 9. |
Hey Tony!
Quick question, our neighbourhood was vandalized the other day, red spray paint on a ton of hou ... |
| 10. |
I have a decking question. I have a 24 foot by 12 foot deck the spacing between all 4X4's are 4 feet. Not t ... |
| 11. |
Hi Tony,
Making a 4 ft. high wall around a stairwell that leads to a basement. It will be "L" shaped, the sh ... |
| 12. |
I just hired a company to sand and polyurethane my hardwood floors. They used a waterbased urethane and I wan ... |
| 13. |
hi, my grandmother recently had her soffit/facia replaced. after the small job, she noticed that there was mou ... |
| 14. |
I would like to enclose my home's carport (1960 era) to build a garage. This is a bungalow with the roof that ... |
| 15. |
We are building a new country style home and we are debating on 8 or 9 ft ceilings. Also considering the cost ... |
| 16. |
We have aluminum soffits. They have small holes throughout them. Above them is plywood that covers the soffi ... |
| 17. |
Hi, I have a second question. I looked behind our drywall (on an exterior wall). There is insulation but no ... |
| 18. |
Tony,
I am a carpenter that needs to be refreshed on laying out a commond rafter. Do I take half the width ... |
| 19. |
Hello,
I am thinking about renovating and adding onto an older home located at 343 Rairmont Ave in Ottawa. ... |
|
|
|
